Hello Guest it is April 19, 2021, 12:28:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mtaylor18

Pages: 1
1
General Mach Discussion / Pin out for probe function
« on: March 29, 2012, 01:05:56 AM »
I would like to use the probe function with the 2010 screenset, but on the input screen where it is enabled it has a note saying you can only use pins 10-13 and 15. Unfortunately the control I am using has all 5 pins enabled. There are other pins available in the control that are not used because it is not a 5 axis controller. My question is, will Mach3 recognize signal if I set it for pin 16 or 17 which are the pulse pins for the 5th axis? (not used in my controller) Gerry, if you read this, your 2010 screenset is awesome. I only hope I get to use the auto probe. Is there another work around for this.? (Anybody????)

Thanks in advance, ???
Martyondrums

Pages: 1