Hello Guest it is March 29, 2024, 03:59:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - johncc

Pages: 1
1
General Mach Discussion / New license
« on: May 13, 2012, 03:59:56 AM »
Hi all, I have had Mack3 for a wile now and have just paid for my license and now I have no stepper motor movement, the software still shows movement, I had a look in Device Manager - ports , and found that there is a new Printer port  (LPT1) so “if” this is the problem how do I set it up? Before adding the license it was working fine.  ???

Pages: 1