Hello Guest it is March 29, 2024, 03:01:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Chaparro1973

Pages: 1
1
General Mach Discussion / Mach 3 mesaures per unit
« on: March 12, 2012, 05:24:39 AM »
Hi
I have juste maneged to set my CNC working.
I have set the motor pulses ok.
Set native unites in mm
On the automatic setup, i tell the machine to move 10 units and it moves 10mm (i guess that wath it's suposed to do).

I guess that is everithing ok!

When o load a G-code it seams tha mach 3 converts mm into cm, the code that i load is too small.
Is that ok or should i set the pulses soa that the machine moves 1cm per unit?

Pages: 1