Topics

1

General Mach Discussion / Wabeco F1210E retrofit?

« on: March 27, 2007, 01:52:08 PM »

I have a new Wabeco F1210E (high speed) 3 axis mill. I’m not sure if it has stepper or servo motors. I also have a motor control box that accepts input from a PC serial port. The thing came with NCCAD6 which barely functioned and I upgraded to NCCAD7 that is marginally better (unless perhaps, if you speak German).

I'd like to swap out NCCAD for Mach3 and save my motor control box and just substitute Mach3 for NCCAD on the PC. Can nayone offer guiadance on how to make this set-up work or is the Wabeco control box too proprietary?...Scott