1
General Mach Discussion / mchine is moving in Metric? instead of inches
« on: September 22, 2012, 04:49:58 PM »
Hi. While running mach3 today, instead of it moving in inches, it seams to be moving possible in metric? I will jog in the width of a 1/2" bit and it will say it moved +13.78 or similar number instead of .5. Any thoughts on what I might have messed up without noticing it?
I am using cut3D to generate the tool path, yesterday I installed a new post processor since the one I had was in mach arc inch and I was sent the mach inch one. Not sure if this would be the problem or what.
Thanks
Tony
I am using cut3D to generate the tool path, yesterday I installed a new post processor since the one I had was in mach arc inch and I was sent the mach inch one. Not sure if this would be the problem or what.
Thanks
Tony