Topics

1

Newfangled Solutions Mach3 Wizards / Mill wizard

« on: January 13, 2015, 02:34:42 PM »

 new setup of mill wizard . When I load a gcode file from mill wizard to Mach3. The machine moves as it should but the mach3 screen dro does not match the amount traveled. This causes my z axis to trip limit switch.   5 inches of travel will read .5 inches on mach3 screen this is a guess of actual ratio between actual travel and screen readout. Any suggestions?  Mach3 running on windows 7.  Thanks Ed cova