Hello Guest it is March 28, 2024, 09:00:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - WimBun

Pages: 1
1
General Mach Discussion / Operating a punch machine via Mach3
« on: February 20, 2012, 05:37:48 AM »
I recently bought a CNC punch/nibble machine (Swedisch Pullmax P 210 dcm) The machine is 25 years old and is controlled by a TRS80 like homecomputer with Z80A processor. Working: The(steady)  tool of the machine punches little holes and by moving the table it can cut out figures out of sheetmetal or aluminium.  I would like to replace the Z80A computer by a Mach3 solution. I don’t see many problems by taking over the control over the X and Y axes.  But the punching tool is another issue. My question is: Is this done before and how do I control the punching movement?  I read in a manual about PWM Motor Control but I am not sure if this is a solution.

Pages: 1