Topics

1

General Mach Discussion / Z-Axis ramping

« on: February 18, 2012, 08:47:31 AM »

Hi All, I've just completed my CNC router. One thing i can't figure out is how to set the z-axis so it makes its complete plunge before moving in another direction. Right now z-axis, from the rapid position, stops about 0.080" from the material to be cut then ramps down to 0.000 as it travels in a horizontil direction. I'm sure there is setting i can change but after an searching most of the day in these forums and in my mach settings I can't find anything that tells me where to make the change.