1
FAQs / Problem circles
« on: April 09, 2012, 11:36:50 PM »
Hi all...
Not sure how to word my question to make it less confusing. I have a program that I have been running on my Taig mill for years. I made zero changes to it and set up to machine out some parts yesterday. Upon a dry run I noticed it was entering the circle via an entry circle, then immediately doing a rapid quarter circle the other direction, then rapidiing another quarter circle back to almost the start point and then proceeding with the .5" circle it was supposed to cut. I sent this out to Kurt at Taig and he plugged it in to his computer at Taig and it ran fine. I have uninstalled the Mach software and reinstalled it all an my license and got the same results.
Thanks in advance!
Bill
Not sure how to word my question to make it less confusing. I have a program that I have been running on my Taig mill for years. I made zero changes to it and set up to machine out some parts yesterday. Upon a dry run I noticed it was entering the circle via an entry circle, then immediately doing a rapid quarter circle the other direction, then rapidiing another quarter circle back to almost the start point and then proceeding with the .5" circle it was supposed to cut. I sent this out to Kurt at Taig and he plugged it in to his computer at Taig and it ran fine. I have uninstalled the Mach software and reinstalled it all an my license and got the same results.
Thanks in advance!
Bill