Hello Guest it is March 29, 2024, 09:23:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - NORTONXSU

Pages: 1
1
Mach4 General Discussion / Mach4 lathe threading with UC100
« on: November 19, 2017, 02:12:43 PM »
Hi all, after many years running my Mirac lathe on Mach 3 I have upgraded to Mach4.
My old setup on Mach3 with UC100 allowed me to thread successfully  with a single pulse per rev index signal.
However on my Mach4 setup when I try to thread Mach4 freezes on the 2nd G76 line.
All other functions work fine, Mach4 is seeing spindle index pulse, rpm indication is spot on and feed per rev works OK.
Any suggestions?

Pages: 1