1
General Mach Discussion / Pause between g-code steps
« on: February 07, 2012, 03:11:01 PM »
New here.. looking for help with a Mach3 issue. Sorry if this is the wrong place to start this thread.
When running a program, there is a short pause between g-code moves.
I have checked that it's set to Constant Velocity not Exact Stop. Any other ideas on how to fix this?
Could very well be my g-code is poorly written and it's not a Mach3 problem at all...
Thanks,
cbade
When running a program, there is a short pause between g-code moves.
I have checked that it's set to Constant Velocity not Exact Stop. Any other ideas on how to fix this?
Could very well be my g-code is poorly written and it's not a Mach3 problem at all...
Thanks,
cbade