Hello Guest it is December 05, 2021, 10:17:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rideright

Pages: 1
1
General Mach Discussion / Amp readout for torch height control
« on: December 19, 2013, 11:46:30 AM »
I am using volts only to control my torch height but when the torch fires the DOR for amps goes to 255 and stays there.  This is making my torch jump up as soon as it is fired.  Is there a way I can ignore this input or force it to zero?  I have changed the torch control card and cables but there is no change.  I can turn the THC off at the begging of the cut then turn it on after it starts and everything works.  The DOR for amps still reads 255 but it works off of volts.

2
General Mach Discussion / Head Rises on M3 command
« on: February 09, 2012, 12:56:06 AM »
Is there a setting that automatically raises the Z axis anytime the M3 command is given?  If there is where is it and how can I turn it off?

3
General Mach Discussion / Plasma Z axis raises when torch is fired
« on: February 07, 2012, 06:27:41 AM »
I have a PlasmaRout table with a MP3000 torch height control.  It has a floating head on the torch.  I have set my offset distance in my postprosser and it looks good.  The problem I am having is the torch goes down makes the switch raises and rezeros.  It then moves to the pierce height but when the torch triggers it raises again then drops to the cut height.  Is this a setting in Sheetcam, if it is I can not find it in the G_Code, or a Mach setting?

Pages: 1