Topics

1

FAQs / which way is xy as i stand at my mill?

« on: March 19, 2012, 10:08:19 AM »

As I stand in front of my Taig CNC shouldn’t tool path xy starting point be lower left when I setup my milling job? Mach 3 tool path shows lower left but when I start the cycle (I’m doing air cuts just to be safe) I have to reset everything to upper right. I did have to reverse my x axis to move in the right direction, but that shouldn’t effect where xy starting point is?

2

FAQs / Importing files from Turbocad

« on: January 29, 2012, 09:36:19 PM »

can I use my 2D/3D files from Turbocad with Mach 3 to make G codes