Hello Guest it is October 30, 2020, 03:07:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - prototype

Pages: 1
1
General Mach Discussion / Consistency
« on: March 12, 2012, 10:15:08 PM »
I am trying to calibrate my mach3. It is consistently off. It overtravels about. 030 in positive direction and under travels about. 02 in negative direction.

Sent from my DROIDX using Tapatalk

2
General Mach Discussion / accel and velocity
« on: January 26, 2012, 01:28:16 AM »
is there a formula to know what the accelleration and velocity need to be set at? when i set it to 20ipm feedrate, not sure if its right or not. and its not cutting correctly in arcs, circles, or engraving. seems to be gaining steps. also i have servos but not sure why encoders arent recognizing that it is out of position. im hoping it can be fixed by getting accel and vel correct. Thanks

Pages: 1