Hello Guest it is March 29, 2024, 01:52:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - funskypilot

Pages: 1
1
I just purchased a Bobcad-cam RT5050 and the previous owner used DOSS to operate it.  The older computer has Windows XP and a 37 pin plug on both ends from the computer to the controle.   This is a 3 axis machine with 8 wire Applied Motion Products syncro stepping motors. I bought the full plate of Bob Cad- Cam software and Mach 3 Mill, lathe, and plasma. What can I do to get some movement out of this thing. I have a background of wiring aircraft radios so if you have a pine change from 37 pin to the 25 pin printer port I can handle it.  I am so frustrated.  I have 2 new Bobcam controllers so I hope to be able to use them.  The prev owner bought a software program of Quickstep 3 and I'm not familiar with it  Any help would be appreciated    Ron in Michigan

Pages: 1