1
General Mach Discussion / Losing Steps on x
« on: November 19, 2012, 11:15:11 AM »
Hello, I was wondering if someone could give me a few ideas to try. I am out of ideas for fixing this problem. Here's some background on my machine. I run a gecko540 using a parallel port. I had issues with my first machine because it didnt have a parallel port, so I had to add a card with a parallel port. The problem was that that machine only uses PCIe. All the cards that are PCIe dont work well with my geck540. So I decided to upgrade to an older machine with a parallel port.
So here is my problem. WIth the new machine, my machine loses steps to the left somewhere in the middle of cutting. I take that same gcode, and run it on my old machine (after I plug it back in) and it doesnt lose steps. So its not the gcode or the physical CNC. There has to be something wrong with the other machine. I have no idea where to start. I am using the same mach file from one machine to the other, so the settings are all exactly the same.
Thanks
So here is my problem. WIth the new machine, my machine loses steps to the left somewhere in the middle of cutting. I take that same gcode, and run it on my old machine (after I plug it back in) and it doesnt lose steps. So its not the gcode or the physical CNC. There has to be something wrong with the other machine. I have no idea where to start. I am using the same mach file from one machine to the other, so the settings are all exactly the same.
Thanks