Guest
Show Posts
1
General Mach Discussion / Z home goes past 0.0 to +1.0
« on: January 27, 2012, 04:10:02 PM »
hello, I can not stop my Z axis from going +1.0 when I try to take it to 0.0 it always goes past 0.0 and the dro readsz +1.0 (past work top)
I can lift the axis, push zero, the dro will read sero, and if I push go home, it moves the Z axis past 0.0 again to +1.0
can someone help me with this, it seems to have started doing this out of no where,
please keep in mind, I am still in setup of this kmachine, but it did work at one point
Thanks!
I can lift the axis, push zero, the dro will read sero, and if I push go home, it moves the Z axis past 0.0 again to +1.0
can someone help me with this, it seems to have started doing this out of no where,
please keep in mind, I am still in setup of this kmachine, but it did work at one point
Thanks!