Hello Guest it is July 17, 2019, 07:15:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Korben

Pages: 1
1
General Mach Discussion / #500 line stop with license version
« on: January 10, 2012, 04:20:52 PM »
Hello,

I'm a new Mach3 user, I found a lot of topics concerning my problem on this forum but didn't found any solution...

I have the License version of Mach3 installed on my PC (Win XP SP2 Home Edition). I verified, it's the License version (my name is written, Licensed To: "me")
but I still have the 500 lines limit which message "End program" when arriving at the line 500 and that with all G-code I tested.

I put this version on another computer (Win 7 Ultimate but no parallel port) and it works perfectly: mach can go over the #500 line.

so if you have any solution...

Thanks for your time.

Korben

Pages: 1