Hello Guest it is July 27, 2021, 03:43:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - zoe

Pages: 1
General Mach Discussion / Help !!..New to CNC .. KX3 question and mach3
« on: December 24, 2011, 10:11:01 AM »
Hello all...

 This is my first post. I am new to CNC and just purchased a sieg KX3 and have a question. Is it possible to use Mach3 with the Sieg KX3 that has a Cat5 interface instead of the parallel port. If so how do I go about it. I have google and searched everything I know. Thank you for any help in advance


Pages: 1