1
General Mach Discussion / Need Help Controlling Spindle
« on: December 24, 2011, 07:04:59 AM »
Ok I've connected my VFD to my breakout board but cannot seem to get mach to do anything.
Attached are pictures of the terminals of both. I have wired:
Vin to +10V
Out to FiV
0V to GND
CP1 to FWD
CP2 to GND
If I'm honest this was just my best guess at what should go where.
problem is i'm not sure if I'm not setting it up right in Mach or if i've wired it wrong so it can't work....
Attached are pictures of the terminals of both. I have wired:
Vin to +10V
Out to FiV
0V to GND
CP1 to FWD
CP2 to GND
If I'm honest this was just my best guess at what should go where.
problem is i'm not sure if I'm not setting it up right in Mach or if i've wired it wrong so it can't work....