Hello Guest it is March 28, 2024, 12:26:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mwpeters49

Pages: 1
1
General Mach Discussion / Corners not sharp when using a plasma
« on: March 28, 2012, 01:48:05 PM »
We are using a Mach 3 with CandCNC hardware.  When we cut at higher speeds (200 ipm or more) the sharp corners of our cuts are rounded.  We know there is a setting in Mach 3 to resolve this but the fellow who knew this software has returned to college and we don't know what he did to resolve this issue.   Can anyone tell me how to fix this? :P

2
Mach3 and G-Rex / Evaluation Limit Reached
« on: December 16, 2011, 03:00:51 PM »
We have a Mach3 controller and we are using a CNCandC hardware.  We've run the program sucessfully before but now we are getting an error when we run the post processor "Evaluation Limit Reached"    What in the hell does that mean?  It is a licensed copy.

Pages: 1