Hello Guest it is March 28, 2024, 11:02:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - scotprop

Pages: 1
1
General Mach Discussion / home switches
« on: January 03, 2012, 10:40:11 PM »
Hi I am a newbie with the cnc thing I am setting up my machine I have everything working until I tried setting up home/limit switches. I have 3 NC switches wired in series with one end (com) going to post 1 on my g540 which is pin 10 and the other going to my DC-. My ports and pins in mach3 are set set correctly but when I go to the diagnostic tab The m1 m2,m3 home leds do not light when I activate a switch. If I go back into port/pin-imput signals and unclick active low all the leds light up but are not effected when I activate a switch. I must be missing something But I am stuck Any ideas would help
Thanks

Pages: 1