1
General Mach Discussion / Crazies Motors !!!... Please Help!!!
« on: December 19, 2011, 06:33:57 PM »
Extreme Newbie here. I have a homemade CNC and it was running fine for a month.
Now, I have a problem with two of my motors (Y and Z axis). When I specify an UP move
It go UP or DOWN, randomly. Same if I specify a DOWN move.
I reinstalled the MACH3... but same.
Both Stepper Motors are HT23-280-8 from Robotix.
The third one (X axis) is a HT23-400-8.
All in parallel.
Gecko540.
Mach3.
Would one of you kind souls please enlighten me?.
Thanks.
Frank
Now, I have a problem with two of my motors (Y and Z axis). When I specify an UP move
It go UP or DOWN, randomly. Same if I specify a DOWN move.
I reinstalled the MACH3... but same.
Both Stepper Motors are HT23-280-8 from Robotix.
The third one (X axis) is a HT23-400-8.
All in parallel.
Gecko540.
Mach3.
Would one of you kind souls please enlighten me?.
Thanks.
Frank