Hello Guest it is December 07, 2021, 02:04:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sdubfid

Pages: 1
1
SmoothStepper USB / smoothstepper and dmm breakout board
« on: November 25, 2011, 08:18:49 PM »
I know some of you are using the smoothstepper with the dmm breakout board.

I am having trouble setting mine up.  Everything works fine with the dmm board when hooked up to the parallel port.

I have installed the smoothstepper plugin.  It keeps giving me an error "external e-stop requested" in mach.  When I change the estop to active low the error gos away but I can not jog any of the axes.

The ss light is flashing red and the green light is solid.  I have the ribbon set to port 1 and all the pins are the same setup I used with the parallel port before the smooth stepper.


Pages: 1