1
General Mach Discussion / Power cut caused mach3 problems
« on: November 24, 2011, 06:54:31 AM »
Hi,
Had a Power cut while Mach 3 was open and the PC switched off suddenly. When started back up the home and fixture position was different. Also the X axis has switched, i.e. when jogging X go's in the opposite direction now. Also I have a 'Normal Condition' LED flashing on the Home Page ( when clicked it says 'Axis are not re-fed to normal position').
Any help or suggestions of how I get back to normality greatly appreciated. I am a newbee and only in my first few days of Mach 3.
James
Had a Power cut while Mach 3 was open and the PC switched off suddenly. When started back up the home and fixture position was different. Also the X axis has switched, i.e. when jogging X go's in the opposite direction now. Also I have a 'Normal Condition' LED flashing on the Home Page ( when clicked it says 'Axis are not re-fed to normal position').
Any help or suggestions of how I get back to normality greatly appreciated. I am a newbee and only in my first few days of Mach 3.
James