Guest
Show Posts
1
General Mach Discussion / Problem with the circle
« on: March 15, 2007, 09:00:35 AM »
I am dutch and i have a problem with the circle.
The I or J = 10 and the diametre is 20 mm but i get 22.2mm, if i use I or J 15 then i get 33.3mm.
When i do it with a trangle it is oke, everithing is fine, the machine is working correct.
i have switsch of the compensation so this is to not the problem.
What do i wrong.
Help me please.
Thanks
The I or J = 10 and the diametre is 20 mm but i get 22.2mm, if i use I or J 15 then i get 33.3mm.
When i do it with a trangle it is oke, everithing is fine, the machine is working correct.
i have switsch of the compensation so this is to not the problem.
What do i wrong.
Help me please.
Thanks