1
G-Code, CAD, and CAM discussions / Gcode tool path not cutting properly
« on: January 13, 2012, 12:41:59 PM »
Can someone look at this GCode and see if they notice anything wrong with it? The pockets were created in CamBam and then produced the GCode. I run the code in a similator and the tool path is correct. I pull it into Mach3 and the tool path looks correct but when it runs. The first two pockets are correct then the next 6 are smaller and then the next pocket the tool runs out of control.
Any help would be great!
Thank you,
Zach
zach@pelicansuperstore.com
Any help would be great!
Thank you,
Zach
zach@pelicansuperstore.com