Hello Guest it is March 28, 2024, 10:41:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Mike_lera

Pages: 1
1
General Mach Discussion / need some help please
« on: March 25, 2013, 03:29:09 PM »
Hi all
i am at whits end!
my machine wont cut a round circle it has flat spots on the X axis
i have checked run out for movement, i took apart the ways and cleaned them, readjusted the gibs,
tried a diffrent wizard
what am i  missing
it has always worked before
chasing my tail
thanks in advance
Mike

2
General Mach Discussion / spindle speed display
« on: November 07, 2011, 01:34:52 PM »
Hi all
I need some direction on getting the spindle speed to display on Mach. I have a single pulse per revolution from my spindle and don't have any idea where to land it ( under ports and pins i find nothing as an input for spindle speed ) I have available pins, I have set up the spindle, just don't know what to pick (input 1, timing, dro ) thank you in advance ???

Pages: 1