Hello Guest it is March 29, 2024, 10:29:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nicholas

Pages: 1
1
General Mach Discussion / Retrofitting a cnc mill
« on: March 15, 2007, 02:15:03 AM »
I have a 1987 comet 3 axis cnc mill with a trak cnc2 controller.
I cant get the y axis to move, displays a vel fault.
I would like to upgrade to mach 3.
Will I be able to use any of the existing equipment.
The servos are indiana general 4040d 280 oz. 70volt brushed.
not sure the type of rotary encoder on the end of the motor.
The sensors are the gage wheel type for the dro
I put a pic in the gallery.
Thanks
Nick

Pages: 1