Hello Guest it is April 25, 2024, 02:47:26 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sdalcher

Pages: 1
1
Third party software and hardware support forums. / Depco CNC lathe, rebadged sherline
« on: October 11, 2016, 12:12:37 AM »
Picked this up for next to nothing, wondering if anyone else is running one with Mach? If so was there anything special needed? I have converted a compact 5 cnc to use Mach 3 in the past. Would also like to see initial configurations of someone successful conversion.


2
General Mach Discussion / Mach3/Taig/micromill2000HD setup help
« on: November 12, 2011, 09:14:10 AM »
Hi all,

Bought this setup some time ago and never had the time to setup. I have spent the last several nights going through relevant posts that I could find. Here is my problem: X and Y steppers will activate in hold position but will not jog. I have tried adjusting the steps up and down as well as adjusting the acceleration and velocity. Best return on this was minute twitter of the axis, but no jog. I have reloaded Mach3 and rebooted, I have installed the correct xml file. I am running out of options and thinking that it is most likely something small that I am overlooking. any help would be appreciated.

Pages: 1