Hello Guest it is December 08, 2019, 02:26:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - purelogic

Pages: 1
1
Purelogic RnD Ethernet pendant for Mach3 PLCM-R1
Website: plmotion.com

  • Mach3 full support
  • Ethernet connection, 5V dc power supply(can be powered by USB)
  • 4 axis control through manual rotary encoder
  • Spindle speed control
  • FeedRate override control
  • 7 programmable buttons
  • 7 programmable LEDs

2
Purelogic RnD new USB tiny Mach3 motion controller PLCM-LPT2

Interface: STEP/DIR/ENABLE
Max. freq: 100KHz
Size: 86x82x20
Pins: 1 port (same to standard LPT ports), 12 "out" and 5 "in" pins. All ins and outs are buffered.
Site: http://plmotion.com

Main features:

  •    USB Full-speed connection
  •    Up to 6 axes, 100kHz pulsing engine
  •    PWM spindle control
  •    Probing
  •    Torch Height Control
  •    Slave Axis support
  •    Soft limits
  •    Easy firmware update
  •    DB25F connector to reproduce standard LPT connection
  •    DLL for direct access to controller could be provided



3
Welcome to discuss!

Interface: STEP/DIR/ENABLE
Max. freq: 100KHz
Size: 86x82x20
Pins: 3 ports (same to standard LPT ports), 36 "out" and 15 "in". All ins and outs are buffered.
Site: http://plmotion.com



Features:

    Ethernet(using TCP/IP) or USB Full-speed connection
    Up to 6 axes, 100kHz pulsing engine
    PWM spindle control
    Probing
    Torch Height Control
    Slave Axis support
    Soft limits
    Easy firmware update
    DB25F connector to reproduce standard LPT connection
    DLL for direct access to controller could be provided
    Power supply 5Vdc or USB
    Power-over-Ethernet(optionally)



Pages: 1