Guest
Show Posts
1
General Mach Discussion / Mach3 and Precimill M4
« on: October 18, 2011, 01:42:08 AM »
Hi everyone!
I am looking for new control software for an old machine. It is an old dental mill from DCS, the Precimill M4. The manufacturer has closed business and the software is most likely from the last century.
It is basically 3-axis machine with material flipper, automatic tool change and Alfred Jäger spindle (KS3-18-60).
I have been looking towards Mach3 for some time now, even tried to configure it a few times, but had no luck on my own.
So I decided to register and post a topic on this forum to get some help with it.
I attached some schematics about the machine. Take a look and give me your opinion if this software is the right one for me.
If someone can give me some help configuring the soft, it would be great.
Thanks for your attention.
Regards,
Rauno
I am looking for new control software for an old machine. It is an old dental mill from DCS, the Precimill M4. The manufacturer has closed business and the software is most likely from the last century.
It is basically 3-axis machine with material flipper, automatic tool change and Alfred Jäger spindle (KS3-18-60).
I have been looking towards Mach3 for some time now, even tried to configure it a few times, but had no luck on my own.
So I decided to register and post a topic on this forum to get some help with it.
I attached some schematics about the machine. Take a look and give me your opinion if this software is the right one for me.
If someone can give me some help configuring the soft, it would be great.
Thanks for your attention.
Regards,
Rauno