1
SmoothStepper USB / New ess install, can not get smooth stepper to write to XML
« on: October 06, 2012, 08:46:57 PM »
Back Ground: Old computer finally kicked the bucket (xp system with mach3 parallel port setup no ss, served me well for 6 years) Have new computer running win 7 32bit, installed new ess.
I have loaded the latest mach3 (066), and ess V10fb2 driver. ran through the normal setup and cannot get the plugin to right any changes to the XML file (when I restart mach3 it is like a fresh install). Checked for read only conditions on XML already.
Questions;
1. Does the ESS hardware have to be installed and connected in order to write to the XML file?
2. When you make changes to the ss pugin config in mach3 does it actually write code in the xml or somewhere else?
3. Any suggestions ?
I have loaded the latest mach3 (066), and ess V10fb2 driver. ran through the normal setup and cannot get the plugin to right any changes to the XML file (when I restart mach3 it is like a fresh install). Checked for read only conditions on XML already.
Questions;
1. Does the ESS hardware have to be installed and connected in order to write to the XML file?
2. When you make changes to the ss pugin config in mach3 does it actually write code in the xml or somewhere else?
3. Any suggestions ?