1
General Mach Discussion / Z start height
« on: October 23, 2022, 06:03:50 AM »
Morning all finaly got a work around to get my machine up and running,
On doing so i need to alter some code in one of the files.
Symtoms
When i start a Gcode of to machine the Z axis comes down to +60mm above the work plane. then the spindle fires up and work commences.
my issue is I have a job thats 100mm thick and i only have 22mm above the material and cutter.
any easy way to change that 60mm to 20mm??
regards Tom
On doing so i need to alter some code in one of the files.
Symtoms
When i start a Gcode of to machine the Z axis comes down to +60mm above the work plane. then the spindle fires up and work commences.
my issue is I have a job thats 100mm thick and i only have 22mm above the material and cutter.
any easy way to change that 60mm to 20mm??
regards Tom