1
General Mach Discussion / Gerber files to G Code
« on: September 15, 2011, 04:48:09 PM »
Hi,
I am think of using a router that uses Mach3 to control and would like to know if the software can import Gerber files. The use would be for PCB prototyping and there are a fw gerber files that need to be imported. They are a top layer, botom layer, drill file and keep out layer.
Any ideas?
Many thanks,
Steve
I am think of using a router that uses Mach3 to control and would like to know if the software can import Gerber files. The use would be for PCB prototyping and there are a fw gerber files that need to be imported. They are a top layer, botom layer, drill file and keep out layer.
Any ideas?
Many thanks,
Steve