Hello Guest it is May 16, 2021, 11:42:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Q_alsayed

Pages: 1
General Mach Discussion / i need help in setting up the Mach
« on: September 11, 2011, 06:54:25 AM »
I need some help. I bought new machine with 3 axis. Also im new in  CNC. I face problem with the setting up my machine. After I start running the program(G code), in the middle the program is stop due to Estope. Is there any part I need to check. I was thinking that happened because I have the free copy. But already I bought the license. 
I appreciate your support.

Pages: 1