Hello Guest it is March 28, 2024, 12:53:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Rex

Pages: 1
1
General Mach Discussion / Torchmate/Mach3
« on: September 23, 2011, 09:44:16 PM »
I am new to M3 and i am setting up a plasma table for work. I use Torchmate at home on my machine. My question is in torchmate it has the option to turn on the torch any time it sees G1,G2,G3 and off for any other code. this makes writing g code very simple. Does Mach3 have this option?    Thanks, Rex

2
LazyCam (Beta) / LazyCam will not post Gcode anywhere
« on: September 09, 2011, 03:50:37 PM »
Yes this is a licensed copy, if i in port a simple square or any shape and post, it will go but if i pocket or offset it will not post.Yes I deleted the original shape. i am getting my a$$ chewed out by my boss for this. he wants to know why he bought your program if it does not work? and yes i do load lazycam from mach3. it wont post to a folder either.

                                                                                                                                                                                                                    Thanks Rex

Pages: 1