1
General Mach Discussion / No motor movement
« on: March 03, 2007, 10:25:29 PM »
Hi to everyone,
I am biulding a square column mill conversion and hooked up the X,Y and Z axis yesterday. despite having Mach3 fully operational, pendant working etc there seems to be no comnunication between the computer and the motors, I have checked the port addresses and everything seems to be in order, the only thing that happens is when the engage armature switch is selected the axis all move one way until disengaged or hit the end of travel. It probably is something really simple that Im missing however any help would be welcome.
Thanks
Phil.
I am biulding a square column mill conversion and hooked up the X,Y and Z axis yesterday. despite having Mach3 fully operational, pendant working etc there seems to be no comnunication between the computer and the motors, I have checked the port addresses and everything seems to be in order, the only thing that happens is when the engage armature switch is selected the axis all move one way until disengaged or hit the end of travel. It probably is something really simple that Im missing however any help would be welcome.
Thanks
Phil.