Hello Guest it is October 16, 2019, 08:50:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - john757

Pages: 1
General Mach Discussion / Pulse Width Modulation
« on: August 29, 2011, 10:07:18 PM »
I recently installed a PWM board to control my spindle speed. I keep getting the following error: PWM bumped to minimum setting. I can't find this error in any of the docs. What is the problem? Thanks for your help.

Pages: 1