Topics

1

General Mach Discussion / Help! My CNC runs on EMC2, but not Mach3?!?!

« on: August 29, 2011, 09:36:08 PM »

My Taig CNC will respond to jogging and run g-code on the Linux prograM emc2, but not mach3...  

I confirmed the following:

- the driver is working
- the driver test works fine
- my board is an arcsin and has pins 2,4,6 configured for the motor and direction pins configured for 3,5,7. Configured the same way on EMC2
- i use windows 7 32bit professional

i would press the tab key, activate jogging, nothing..  

Any suggestions?