1
General Mach Discussion / Motor tuning Mach3
« on: April 13, 2007, 01:44:47 PM »
How do I know how to increase or decrease pulse, acceleration, velocity when tuning the motors?
I can only manage to get the steppers to buzz but not turning. All three are 3VDC at 3AMPS with 200oz. The board and the motors are from HobbyCNC, and lots of power supplied. The Mach3 on the computer is perfect with all test made before hand.
I can only manage to get the steppers to buzz but not turning. All three are 3VDC at 3AMPS with 200oz. The board and the motors are from HobbyCNC, and lots of power supplied. The Mach3 on the computer is perfect with all test made before hand.