Hello Guest it is March 28, 2024, 05:28:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - pvsekaran

Pages: 1
1
i have installed mach in my pc. i have tested the parallel port and it is working fine. Sanyo denki stepper drive BS1D200P10 does not have step and dir terminals . Instead it has cw ccw teminals .

Vendor's technician could show me stepper motor revolve either in clockwise and after tweaking connections anti clockwise.( without connecting to parallel port)

The User manual does not help.

My problem is " how do i connect" the paraller port pin no 2 and 3 which i have configured as step and dir with the stepper drive

I have attached the user manual of the driver.

would be really helpful if someone helps

PV Sekaran

Pages: 1