Hello Guest it is October 20, 2021, 07:30:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ipc150

Pages: 1
1
General Mach Discussion / mach3 foam cutter heat control.
« on: March 04, 2012, 03:25:27 AM »
I'm korean user mach3. I'm not good at english. I hope you understand my question.
I control heat by dial. very Often i change dial so i cannot choose exact volume.
I hope to control heat by mach3 (use spilndle control)

Do i need any other equipment? (ex. converter ,inverter, ??)

Pages: 1