Topics

1

General Mach Discussion / Camtech Laser

« on: June 10, 2015, 05:09:56 PM »

Has anyone fitted mach to a 40 watt camtech laser cutter and was it successful.

2

VB and the development of wizards / DENFORD TU150

« on: May 30, 2012, 01:01:44 AM »

Please Help Iam stuck I don't know enough vb. I have TU150e this is fitted with a 8 station turret each position there is an output not bcd strange I know. There is a lock/unlock switch . The motor is driven by an inverter the turret indexes in one direction only and then reverses to lock. I am using a Deva 004 servo card everything is working well but stuck on the dam turret. Please help its driving me nuts

3

General Mach Discussion / Carousel Tool Changer

« on: July 31, 2011, 08:10:33 AM »

Hi I am retro fitting a Partner VM15 with mach3 and deva pci motion control card. I am struggling with a tool change macro.
It will have to count the pockets on the carousel store the last pocket,orientate the spindle and move the z axis to the tool change postion.
The pocket count is done with proximity switches and the carousel rotates with a small motor a small piston pushes the carousel out.