Guest
Show Posts
1
One on one phone support. / CHINESE CNC ROUTER DRIVERS AND MOTORS
« on: July 14, 2011, 10:35:16 PM »
HI,
I AM WORKING ON AN CHINESE CNC ROUTER FS 1212. I HAVE REMOVED ORIGINAL INTERFACE AND INSTALLED A PMDX-126 BREAK OUT BOARD. I AM USING THE MACH 3 SOFTWARE TO RUN THIS UNIT. I HAVE THE SOFTWARE COMUNICATING OK, BUT THE MOTOR TUNNING IS NOT WORKING CORRECTLY. I AM NOT SURE IF THE DRIVERS ARE OK TO USE OR IF IT IS MY SET UP. I ALSO PUCHASED THREE GECKO STEPER DRIVES THAT I CAN USE, BUT I WAS TOLD THE ORIGINAL DRIVE WILL WORK FINE. BELLOW IS THE MOTOR AND DRIVER INFO. LET ME KNOW IF YOU MIGHT HAVE ANY INFO.
MOTOR DRIVER NUMBERS: DRIVE #1 2HB808MA, DRIVE #2 2HB504MA, DRIVE #3 2HB504MA
AXIS MOTOR NUMBERS: V PHASE A PHASE 1.8 DEG STEP 021-54804007
THANKS,
TOM, 505-274-1730
I AM WORKING ON AN CHINESE CNC ROUTER FS 1212. I HAVE REMOVED ORIGINAL INTERFACE AND INSTALLED A PMDX-126 BREAK OUT BOARD. I AM USING THE MACH 3 SOFTWARE TO RUN THIS UNIT. I HAVE THE SOFTWARE COMUNICATING OK, BUT THE MOTOR TUNNING IS NOT WORKING CORRECTLY. I AM NOT SURE IF THE DRIVERS ARE OK TO USE OR IF IT IS MY SET UP. I ALSO PUCHASED THREE GECKO STEPER DRIVES THAT I CAN USE, BUT I WAS TOLD THE ORIGINAL DRIVE WILL WORK FINE. BELLOW IS THE MOTOR AND DRIVER INFO. LET ME KNOW IF YOU MIGHT HAVE ANY INFO.
MOTOR DRIVER NUMBERS: DRIVE #1 2HB808MA, DRIVE #2 2HB504MA, DRIVE #3 2HB504MA
AXIS MOTOR NUMBERS: V PHASE A PHASE 1.8 DEG STEP 021-54804007
THANKS,
TOM, 505-274-1730