Hello Guest it is October 22, 2020, 08:25:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - MadDogSTrack

Pages: 1
1
Mach4 General Discussion / MACH4 and ESS with homing issues
« on: May 22, 2015, 02:41:41 PM »
I have Mach3 running without issues on my machine...  Getting ready for the plunge into Mach4 - So i am running in Demo.  I would like to have system at least semi-working before taking the leap.

I have X, Y, Z working as they should, but whenever I try to home any one axis or all axes, Mach4 locks up - stuck in homing.

Specifically Mach4, after pressing Ref or Ref All:
* Selected axis heads in the correct direction to the homing limit,
* Touches the switch,
* Lights the Home switch on Diag. screen, and
* Never backs off the switch
* Never exits the homing sequence

I have to exit Mach4 and start up again to get control of machine.

I have followed DazTheGas videos (thanks!) and must be overlooking something.  Might this be a result of still in demo mode?  Any help is greatly appreciated.

Mach4 v 1.2461 (demo)
ESS v April 19 2015
Win 8.1 64 bit


STrack

Pages: 1