1
PoKeys / UserLed 2055
« on: August 08, 2011, 07:33:26 AM »
Hi again,
as a workaround for the auxiliary bus problems mentioned earlier, I set up my Pokeys55 without the ExtBus.
everything works ok, but I ran into some minor problems again.
1.
I just have digital inputs and outputs + LCD
Configured it to ULED range starting from 2001
Input range 1: 1 to 27
Input range 2: 35 to 45
Output range 1: 46 to 55
everything works fine, except that I can't use SetUserLED(2055,1) in macros, that won't do anything.
all other output LEDs work as expected. (Yet it works in Pokeys config software)
Did I miss something or is there indeed some strange behavior of the Plugin (10.6.4, btw)?
Sidenote: initially I had defined the unused ExtBus (35-37) pins as Outputs, too, so that the settings were
Input range 1: 1 to 27
Input range 2: 38 to 48
Output range 1: 35 to 37
Output range 2: 49 to 55
but then I couldn't set UserLeds 35 to 37. After switching wires and setting to the setup above, that was no longer a problem.
Would appreciate any hints regarding that LED 2055 thing
Regards,
Mike
as a workaround for the auxiliary bus problems mentioned earlier, I set up my Pokeys55 without the ExtBus.
everything works ok, but I ran into some minor problems again.
1.
I just have digital inputs and outputs + LCD
Configured it to ULED range starting from 2001
Input range 1: 1 to 27
Input range 2: 35 to 45
Output range 1: 46 to 55
everything works fine, except that I can't use SetUserLED(2055,1) in macros, that won't do anything.
all other output LEDs work as expected. (Yet it works in Pokeys config software)
Did I miss something or is there indeed some strange behavior of the Plugin (10.6.4, btw)?
Sidenote: initially I had defined the unused ExtBus (35-37) pins as Outputs, too, so that the settings were
Input range 1: 1 to 27
Input range 2: 38 to 48
Output range 1: 35 to 37
Output range 2: 49 to 55
but then I couldn't set UserLeds 35 to 37. After switching wires and setting to the setup above, that was no longer a problem.
Would appreciate any hints regarding that LED 2055 thing
Regards,
Mike