Hello Guest it is November 30, 2021, 11:23:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jonboyusmc

Pages: 1
1
General Mach Discussion / Spindle control setup
« on: July 04, 2011, 01:40:44 PM »
Is there a setting to turn the spindle on without a pulsed output? I have a Paxton/Patterson lathe and mill that I have switched over to Gecko Drives and Mach3. I just want a constant high active signal to pull the spindle relay in with an M03. When I check diagnostics now, I can see the output pulsing and the spindle sounds like hell as the relay keeps opening and closing. I've also got issues with my spindle pulse counter not reading right, but I'll ask about that later. I'm just trying to fix one problem at a time for now.

Pages: 1