Guest
Show Posts
1
NC Pod / NC Pod Ports and Pins questions
« on: March 13, 2007, 03:28:15 AM »
I just got the pod in, and some Gecko 201s and was going through the setup process and I have run into a stumbling block.
I set up the pod and got it talking to the latest version of Mach.
I can turn on and off some of the inputs.
Before I attempted to hook up the Geckos, I wrote a simple program to move the X axis back and forth and them put my scope on the outputs for the step and direction. All I get is steady 5 VDC.
What should the Port and Pin configuration for the Motor outputs be set to?
I set up the pod and got it talking to the latest version of Mach.
I can turn on and off some of the inputs.
Before I attempted to hook up the Geckos, I wrote a simple program to move the X axis back and forth and them put my scope on the outputs for the step and direction. All I get is steady 5 VDC.
What should the Port and Pin configuration for the Motor outputs be set to?