Hello Guest it is March 28, 2024, 10:32:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - axion68

Pages: 1
1
General Mach Discussion / Spindle RPM lock error while threading
« on: June 09, 2011, 01:22:50 AM »
I am setting up a new machine and am stuck on threading using the thread wizard.  I can disable spindle feedback and it runs the code just fine.  If I enable spindle feedback it gets to the point of locking spindle rpm and stalls with a non-numerical number locked(see attached screenshot).  I am picking up a index pulse and mach 3 sees rpm.  Can someone guide me in the right direction?

Thanks
Jacob

Pages: 1